How-To Videos

How to Remove and Replace Wood Decking

By: Danny Lipford
Using a cordless drill and deck screws to attach new wood decking.

Using a cordless drill and deck screws to attach new wood decking.

Wooden decking that has rotted or deteriorated over time will need to be replaced. Start by using a hammer and pry bar to remove the old deck boards. You can also insert a long board between the decking and joists to pry the old deck boards loose.

After all the old decking and nails have been removed, pull a string or extend a straight board on edge across the floor joists to make sure the joists haven’t sagged. Replace or shim up any sagging joists before installing the new decking.

Align the first deck board perpendicular to the floor joists and overhanging the outside edge of the deck. Screw the board in place using 3” long, rust resistant deck screws.

Pressure treated deck boards which have been kiln dried after treatment (KDAT) will expand slightly in width after installation, so use an 8-penny nail as a spacer to leave a 1/8” gap between the boards.

Boards that haven’t been kiln dried after treatment and are still wet with preservative will shrink slightly when they dry, so butt them closely together when attaching.

To straighten a crooked board, attach one end of the board to the deck joists, and then pry the other end into place before securing it.

Leave the deck boards longer than the deck, so they hang over the outer edge of the deck by several inches or more. After all the deck boards have been attached, pop a chalk line an inch or so past the end of the deck foundation and use a circular saw to cut the decking to the finished length.

Watch this video to find out more.

Further Information

Video Transcript

Danny Lipford: In order to re-cover an existing deck, you have to first remove the old rotten deck boards. It’s important to do this carefully so that you don’t damage the framing beneath that you want to keep. Hammers and pry bars will do the job, but you speed up the process by using a long piece of lumber for more leverage to pry the boards free.

When all the deck boards and nails have been removed, inspect the framing for any needed repairs. It will be easier to correct any sags now before you install the new deck boards.

If the long side of the boards will be exposed on one side of the deck, that’s a good place to start with a full board width. When the board is aligned and perpendicular to the joists, begin securing it to them. Coated deck screws are the best method, since they stand less chance of working free. For these two-by six deck boards, we’re using three-inch screws.

This lumber was kiln dried after treatment, so we are using an eight-penny nails as a spacer between each row. Regularly treated boards will shrink after installation, so you may want to butt them tightly together to allow for that.

Occasionally a bow in the wood will require you to secure one end and pry the other end into place before securing it. On the open end of the deck, we’re letting the boards just run long so we can come back later and cut them all at once for a good straight line.


Please Leave a Comment

One Comment on “How to Remove and Replace Wood Decking”

You can follow comments to this article by subscribing to the RSS news feed with your favorite feed reader.

  • Susan Wingard Says:
    November 10th, 2016 at 4:20 pm

    Dear Mr. Lipford,
    I’m a loyal viewer and every time I watch your show, I dream about, I wish it’s my house that they are fixing. I am retired woman living alone and on a fixed income and cannot afford the repairs. I have several “to fixed list”. The fog on my window, backyard ground is sinking causing crack on my driveway, the water/rain is going inside the floor and other repairs to be done. I tried to fixed it myself esp. the crack in my driveway, I used quickrete but after a year, the crack is back. Old deck, I tried to cover it with “Deck Over” but the structure is unstable. How do you select the house that you featured on the show? Could I apply for that? Thank you. I love your show!! Thank you.
    Susan Wingard

We want to hear from you! In addition to posting comments on articles and videos, you can also send your comments and questions to us on our contact page or at (800) 946-4420. While we can't answer them all, we may use your question on our Today's Homeowner radio or TV show, or online at

 characters available

How to Remove and Replace Wood Decking